Inserting Bobbin Case; Bringing Up Lower Thread - Pfaff SZA-645F Instructions Manual

INSERTING BOBBIN CASE
Be sure that 15 cm of thread extends
out of bobbin.
Hold bobbin case so long finger on
case points up. Open latch.
Slip case over center pin in shuttle and
press in place until long finger enters
notch. Release latch, and press down.
Close slide plate.
BRINGING UP LOWER THREAD
Raise presseT foot. Hold needle thread
loosely with your left hand.
Turn
hand wheel toward you until needle
moves down and then up again to its
highest
position, catching bobbin
thread and bringing it up through hole
in needle plate.
To prevent thread from slipping out
of needle when you begin sewing, pull
both threads out about 15 cm and
place under presser foot toward rear
of machine.
—
10—