Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - KitchenAid KUDR01TJ Use & Care Manual

Quick
CleanUp
Use this cycle for a quick wash ......
and light dry to cleanup
cookware prior to entertaining.
The sensor adds water and Use main
time to the cycle, if needed, for detergent
maximum cleaning, This cycle dispenser
uses a shortened dry time. section.
Towel drying may be needed.
Water Rinse Main Rinse Final Dry Time Water
Temp Wash Heated (min) Usage
Sensed Rinse (gaUL)
Hot • • • • 44" 5,2-6.5
/20-25
Cold • • •
48" 7.1-8.2/
27-31
Rinse
Use this rinse cycle for
Only
rinsing dishes, glasses, and
_ silverware that will not be
washed right away. Do not use
detergent with this
cycle.
Soil Pre- Main Rinse Rinse Final Dry Time Water
Level Wash Wash • Heated (rain) Usage
Sensed Rinse (gal/L)
10 1.8/7
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
NOTES:
• The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
• In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
During the first minute of a cycle
Press a new cycle and/or options.
After the first minute of a cycle
1. Press
o
Cancel
Drain
CANCEL/DRAIN glows. The dishwasher starfs a 2 minute
drain (if needed). Let the dishwasher drain completely.
2. Check the detergent dispensers. If the main wash cup has
opened and the detergent washed away, refill the cups as
needed.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause.
Anytime during a cycle, press
CANCEL!DRAIN glows. The dishwasher starts a 2 minute drain (if
needed). Let the dishwasher drain completely. The light goes off
when the dishwasher finishes the drain.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to repeat the same cycle and options as the
previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi-Temp Scrub
Select this option to heat the water during parts of the cycle, and
add a rinse. Higher water temperatures and an extra rinse helps
clean tough soil. Hi-Temp Scrub, with the Heavy cycle, raises the
water temperature in the main wash and the prewash. Hi-Temp
Scrub, with the Normal cycle, raises the water temperature in the
main wash.
This option adds heat, water and wash time to the cycle.
Hi-Temp
Scrub
NOTE: Hi-Temp Scrub is an option with the Heavy and Normal
cycles.
12