Hydro Pump Spring Tension Setting; Electric Clutch Adjustment; Cleaning; Clean Grass Build-Up Under Deck - Exmark Turf Tracer TT20KCE Operator's Manual

Hydro Pump Spring Tension
Setting
1. For medium or heavy duty drive conditions such
as operation with a sulky on steep slopes, a higher
spring force may be required on the hydro pump
control arms to prevent the drive system from
stalling.
2. For a heavier drive setting, relocate the spring
anchor link as shown in Figure 13. The spring
anchor links are located under the engine deck on
the left and right hand sides.
Note: In "medium" or "heavy duty" positions,
the drive lever forces at the upper handle will also
be increased.
Figure 18
1. Heavy duty
2. Medium duty

Electric Clutch Adjustment

No adjustment necessary.
3. Standard
4. Retaining bolt

Cleaning

Clean Grass Build-Up Under
Deck
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Raise deck to the transport (maximum cutting
height) position. Lift the front of unit and support
unit using jack stands or equivalent support.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
3. Clean out any grass build-up from underside of
deck and in discharge chute.

Waste Disposal

Motor Oil Disposal
Engine oil and hydraulic oil are both pollutants to
the environment. Dispose of used oil at a certified
recycling center or according to your state and local
regulations.
33
Maintenance