Electrolux EI28BS56ISB Use & Care Manual page 9

installation 9
Lift the door while adjusting the washer. To
raise the door, rotate washer clockwise (when
viewed from the bottom). To lower door, rotate
washer counter-clockwise (when viewed from the
bottom).
F/
Raising/Lowering Door
Re-tighten the screw (where applicable), ensuring
it is between the spokes of the washer. Screw
will not be tight, just insert until it is flush with the
hinge.
Screw (where applicable)
NOTE
tf after adjusting doors higher the door makes a
popping/clicking sound, remove screw and replace
with the longer one supplied in the handle package.
To adjust the flipper mullion:
1 Loosen the screw located on the flipper mullion
hinge.
ii i
i
iiii i ¸
ii_ _ '_i _i_ii_ii_ i_ii_:i _i _
Screw
Adjusting Flipper Mullion Screw
2 Adjust flipper mullion height. For proper
connection with the flipper mullion guide, there
should be a separation about the thickness of a
coin (0.060 inches, or 1.5 mm) between the guide
and flipper mullion.
>. Guide ]
|
Adjusting Flipper Mullion Height
3 Re-tighten screw.