Table of Contents
Advertisement
6
GROU
Di G INSTRUCTIONS
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-
ing plug. It must be plugged into a wall receptacle
that is properly installed and grounded in accordance
with the National Electrical Code and !ocal codes and ordinances.
In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the electric current.
WA_N_NG
Improper use of the grounding plug can result in a dsk of electric shock.
Electrical
Requirements
The electrical
requirements
are a 120 volt 60 Hz, AC only, 15 amp. or
more protected
electrical
supply, tt is recommended
that a separate
circuit serving only this appliance
be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged
into a wall receptacle
that is properly installed and grounded.
Should
you only have a 2-prong outlet,
have a qualified electrician
install a
correct wall receptacle.
A 3-prong
adapter may be purchased
and used temporarily
if local
codes allow. Follow package directions.
A short power-supply
cord is provided
to reduce risk of becoming
entangled in or tripping over a longer cord. DO NOT USE AN EXTENSION
CORD. If the power supply cord is too short, have a qualified electrician
or serviceperson
install an outlet near the appliance.
NOTES:
!. If you have any questions about the grounding or electrical instruc-
tions, consult a qualified electrician or serviceperson.
2, Neither Electrolux nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe the
correct electrical connection
procedures.
Permanent and Correct Installation
8-Pteng Plug
GroundingPin
[(_
Ground /
Re_p_°l° _x
TemporaryUse
Ground
G_u_ing
Reee_a¢le
_d_r
k
Radio
or TV interference
Should there be any interference
caused by the microwave oven to your radio or TV, check that the
microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.
Advertisement
Table of Contents
