Procedures - Kenmore 41794814301 Owner's Manual

Laundry center
Table of Contents

Advertisement

Drying Procedures
Follow fabric carelabel instructions.
Place small items in a mesh bag.
/
Filldryerdrum 1/3to 1/2 full
• Follow the guidelines below for preparing the load for drying.
• Read Dryer Operating
Instructions for operating your specific model.
• Always read and follow fabric care labels and laundry product labels.
To reduce the risk of fire, electrical shock, or injury to persons, read
Important Safety Instructions, pages 2-3, before operating this dryer.
1.
Prepare
items
for drying.
Dry items of similar fabric, weight and construction in the same load.
Separate dark items from light-colored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out.
Be sure buckles, buttonsand trim are heatproof and won't damage the drum
finish. Close zippers, fasten hooks and Velcro®qike fasteners. Tiestrings and
sashesto prevent snagging and tangling.
If possible, turn pockets inside out for even drying.
Check for stains which may not have been removed in washing. Dryer heat
may permanentl
set some stains. Repeat stain removal process before
drying.
Place small items in a mesh bag to prevent tangling and for easy removal.
2.
Check that
lint screen
is clean and in place.
3.
Load
the dryer.
The averageload willfillthedrum
1/3 to 1/2 fulk Items need room totumble
freely for even drying and less wrinkling. Do not overload dryer.
When drying large items, dry only 2 or 3 at a time. Fillout the load with small
and medium sized items.
For delicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items. Overdrying can causewrinkling, shrinkage, harshness,
and a build_up of static electricity, which can produce more lint.
If desired, add a dryer fabric softener sheet.
4.
Close the dryer
door and set dryer
controls
(some
models).
See Dryer Operating Instructions card for your specific model controls.
5.
Turn cycle selector
clockwise
to the desired
setting.
6.
Start
the dryer.
Turn the Turn to Start control clockwise to ON. Hold for 1-2 seconds and
release.
To add or remove items when the dryer isrunning, open the door. The dryer
will always stop when the door is opened. Allow the drum to come to a
complete stop before reaching inside.
To restart dryer, close the door then turn the Turn to Start control clockwise
to ON. Hold for 1-2 seconds and release.
7.
When
the cycle ends,
remove
items
immediately
and hang
or fold. If load is removed before the cycle ends, turn cycle selector to OFF.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents