Table of Contents
Advertisement
REMOVABLE
OVEN
DOOR
TO remove:
1. Open the door to the stop position (see Illustratton).
2. Grasp the door at each side and lift up and off the
hinges.
NOTE: When the door is removed and hinge arms are at
stop position, do not bump or try to move the hinge
arms. The hinges could snap back causing an injury to
the hands or damage to the porcelain on the front of the
range. Cover the hinges with toweling or empty towel
rolls while working in the oven area.
To replace:
1° Hold the door
over the hinges
with the slots
at the
bottom
edge
of the door
lined
up with the hinges°
The hinge arms must still be in the
stop position.
2, Slide the door down onto the hinges as far as tt will
go and close the door.
HINGE
STOP POSITION
NOTE:
Do not allow water to pan down inside the door.
Open door completelywhen cleaning the top edge.
REMOVABLE
OVEN
RACKS
Be careful not to scratch the oven finish when installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pairof rack
guides,
2o Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way in,
To remove:
1. Pull the oven rack out, then up, in one motion. See
the cleaning chart.
BUMPED-IN
RACK GUIDE
\
REGULAR RACK
OFF-SET RACK
NOTE:
The racks are designed
with stop locks. When placed correctly on the rack support and extended from the
oven, the stop lock prevents the racks from tilting when you are removing food from the racks or placing
food on them.
REPLACIHG
OVEH
LIIGHT
Do not touch hot oven bulb.
Do not
touch
bulb with
wet hands.
Hever
wipe oven light area with wet cloth.
Never
touch
the
electrically
live
metal
collar
on the
bulb when
re-
placing,
To remove:
1. Disconnect electric power to the oven at the main
fuse or circuit breaker.
2. Hold your hand undercover and firmly push back the
bail wire until it clears the cover. The cover will fall
into your hand. DO HOT REMOVE
ANY SCREWS
TO REMOVE
THE COVER,
3. Replace bulb with 40-watt home appliance
butbo
12
To replace
cover:
1. Place cover into groove of lamp receptacle. Pu]I wire
bail forward until it snaps into place. Be certain wire
bail is in center of cover. Wire will hold cover firmly
when in correct position.
2. Connect power to oven.
BULB
BULB COVER
BAIL WIRE
NEMNT81
Advertisement
Table of Contents
