Water And Ice Dispensers - Kenmore 10657076603 Use & Care Manual

Adjusting Electronic Controls
NOTE: Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
• Press the FREEZER or REFRIGERATOR Up or Down Arrow
until the desired setting is reached.
REFRIGERATOR COLDER
COLD
CONDITION: SETTING
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR Control
- Not set correctly for conditions one setting lower
REFRIGERATOR too warm REFRIGERATOR Control
- High use or room very warm one setting higher
FREEZER too cold FREEZER Control
- Not set correctly for conditions one setting lower
FREEZER too warm/too little ice FREEZER Control
- High use or heavy ice usage one setting higher
Slide Controls
For your convenience, your controls are preset at the factory.
When installing your refrigerator, make sure that the controls are
still preset to the mid-settings as shown.
Freezer Refrigerator
C
cold I 2 A 3 4 colder off I 2
A
3 4 colder
IMPORTANT: Your refrigerator will not cool when the Refrigerator
Control is set to OFE
Adjusting Slide Controls
NOTE: Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
• Slide the control one setting to the right to make the
compartment colder. Slide the control one setting to the left
to make it less cold.
CONDITION: SETTING
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR Control
- Not set correctly for conditions one setting lower
REFRIGERATOR too warm REFRIGERATOR Control
- High use or room very warm one setting higher
FREEZER too cold FREEZER Control
- Not set correctly for conditions one setting lower
FREEZER too warm/too little ice FREEZER Control
- High use or heavy ice usage one setting higher
Accelerated Ice Production
The accelerated ice feature assists with temporary periods of
heavy ice usage by increasing ice production over a 24-hour
period.
• Press the ICE touch pad to set the freezer temperature to
-10°F (-23°C). The Accelerated Ice setting will remain on for
24 hours unless manually turned off. The display will continue
to show your normal temperature set point.
If increased ice production is desired at all times, set the
Freezer Control to a colder setting. Adjusting the freezer to a
colder temperature may make some foods, such as ice
cream, harder.
Depending on your model, you may have one or more of the
following options: the ability to select either crushed or cubed
ice, a special light that turns on when you use the dispenser, or a
lock option to avoid unintentional dispensing.
The Water Dispenser
If you did not flush the water system when the refrigerator was
first installed, do so now. Use a sturdy container to depress and
hold the water dispenser lever for 5 seconds, then release it for
5 seconds. Repeat until water begins to flow. Once water begins
to flow, continue depressing and releasing the dispenser lever
(5 seconds on, 5 seconds off) for an additional 2 minutes. This
will flush air from the filter and water dispensing system.
Additional flushing may be required in some households.
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
Allow 24 hours for the refrigerator to cool down and chill water.
IMPORTANT: Depending on your model, the small removable
tray at the bottom of the dispenser is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.
The tray can be removed from the dispenser and carried to the
sink to be emptied or cleaned.
To Dispense Water:
1. Press a sturdy glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
11