Before Setting Oven Control - Kenmore 790.6409 Series Use & Care Manual

Hide thumbs Also See for 790.6409 Series:
Table of Contents

Advertisement

Before Setting Oven Control
OVEN VENT LOCATED
UNDER
LEFT REAR ELEMENT
Oven Vent Location
For models equipped with coiled surface elements, the oven vent is located u rider
the left rear surface element.
When the oven is on, warm air flows through the
left rear element. This venting is necessary for proper air circulation in the oven
and good baking results. DO NOT BLOCK THE OVEN VENT.
Arranging
Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING
THE OVEN). Always use oven mitts when using the oven.
Removing
& Replacing
Oven Racks
To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Rack
RECOMMENDED
RACK
POSiTiONS
FOR
BROiLiNG,
BAKING
& ROASTING
Food
Rack Position
Broiling meats, chicken or fish
1,2 or 3
Cookies, cakes, pies, biscuits & muffins
3 or 4
Frozen pies, angel food cake, yeast, bread,
4 or 5
casseroles,
small cuts of meat or poultry
Turkey, roast or ham
5
Setting
To Operate the Surface Elements:
Surface
& Oven Controls
1.
Place cooking utensil on the surface element.
2.
Push in and turn the surface control knob in either direction
to the desired setting. Start most cooking operations on a
higher setting and then turn to a lower setting to finish cooking. The control knobs do not have to be set exactly on a particular
setting. Use the settings as a guide and adjust the control knob as needed.
3.
When cooking is completed, turn the surface element off before removing the pan. Note: The Surface indicator light will
glow when one or more elements are turned on. A quick glance at this indicator light when cooking is finished is an easy
check to be sure all surface elements are turned off.
The suggested settings found in the chart below are based on cooking in medium-weight
aluminum pans with lids. Settings may vary when using other types of pans.
©©
@
SURFACE
STANDARD
SURFACE
ELEMENTS
Setting
Type of Cooking
HIGH
(HI)
Start most foods,
bring water
to a boil, pan broiling
MEDIUM
HIGH
(6)
Continue
a rapid
boil, fry, deep
fat fry
MEDIUM
(4-5)
Maintain
a slow
boil, thicken
sauces
and gravies,
steam
vegetables
MEDIUM
LOW (2 - 3)
Keep
foods
cooking,
poach,
stew
LOW (SIM)
Keep warm,
melt, simmer
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings
on top
of the range when it is in use. These items could melt or ignite. Potholders, towels orwooden spoons could catch fire if placed
too close to the surface elements.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.9080 series790.9082 series790.6531

Table of Contents