Denon AVR-2805 Operating Instructions Manual page 43

Make this setting to switch the power amplifier for the surreund back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at "SURR. BACK ZONE2 PREOUT" terminals.
Select "Power Amp Assign" at the Option Setup Menu.
@
(Remote control unit)
cI
:_:0 F "t: i O n S e -t: u F
m m ...... -, .............
5. Option Setup
_I. Power Amp Assign
2, Zone2 Vol. Level
3, Trigger Out I Setup
4, Trigger Out 2 Setup
5. Muting Level
6. On Screen Display
?, Setup Lock
Exit
2
(Remote control unit)
G
(Remote control unit)
4
(Remote control unit)
Press the ENTER butten,
Display the Pewer Amp Assign screen.
Select "Surreund Back" to use as the surreund back channel,
"Zone2" to use as Zone2 out.
I
I
:_:i::' ,, i:i m F i:i _: :_; i '_]i'_ I
I
S. E',_ c k I,
5-I. Power Amp Assign
_4:_Zone2
5-1. Power Amp Assign
Sutr0undback 4:_
When "Surreund Back" is selected When "Zone2" is selected
Enter the setting.
The Option Setup Menu reappear.
Set the Zone2 pre-out eutput level adjustment.
1
(Remote control unit)
At the Optien Setup Menu select "Zone2 Vol. Level".
:_: oF: ,_ io,-, , _; e,,, F : ' I
5. Option Setup
1. Power Amp Assign
_2. Zone2 Vol Level
3. Trigger Out 1 Setup
4. Trigger Out 2 Setup
5. Muting Level
6. On Screen Display
?, Setup Lock
Exit
2
(Remote control unit)
Display the Zone2 Vel. Level screen.
43