Denon AVR-2805 Operating Instructions Manual page 22

1
(Remote control unit/
Select "Auto Setup" at the Aute Setup / Reem EQ Menu.
:t H Li "t O !:, e "t _<' O O m _: _!
1. Auto Setup/Room EQ
_1. Auto Setup
2, Manual EQ Setup
3. Room EQ Setup
4, Direct Mode Setup
5, Mic input Select
Exit
2
(Remote control unit)
Display the Auto Setup screen.
Check the "Power Amp Assign" setting.
• When "Surround Back" is selected, the test tene during Auto Setup will be output from the Surround Back speaker.
• When "ZONE2" is selected, change the setting te "ZONE2" The test tone during Auto Setup is set se that it will not be output te
ZONE2 (Another reom).
, i}; Select the Power Amp Assign setting.
(Remote control unit)
1-t. Auto Setup
EYPower Amp Assign
Surr0undBack
Start_
Cancel_
Jt , . Select Surreund Back or"ZONE2".
G
(Remote control unit)
4
(Remote control unit)
:4:i:i u "i: 0 '_ (_:i; Li F:
P, F:Im F : 4 !_;i_i: il'
]) Select the "Start".
:_:Fiu i; o !_;e -t u i-
S -t _i r i; 4
,'2h Press the Curser left butten.
NOTE:
• When "ZONE2" is selected at System Setup Menu
"Pewer Amp Assign", surreund back speaker is net
displayed as the target of setup in "2-1.Speaker
Config.". The results is reflected in "5-1 .Power Amp
Assign".
1-1. Auto Setup
Power Amp Assign
Surr0undBack
_Start_
Cancel_
(Remote control unit)
22