Table of Contents
Advertisement
Types of cooktop elements
The ceramic glass cooktop has radiant surface elements
located below the surface of the glass. The graphics on the
ceramic glass will outline the size and type of element
available. The Warming
Zone and single radiant elements
will have one round outline pattern shown. The dual radiant
element is flexible because you may set just the smaller
inner portion as a single element or both inner and outer
portions may be set to heat together (See Fig. 1).
/
/
\
®
@
Large
OFF
OFF
Element
hi
hi
Io
sire
3
OFF
4
o-'" slm
reed
med
Io
oJ, @
O
Small
Element
hi
hi
6
8
4
7
6
,%",
slm
.e
Io
Warming
Zone
surface
control
(some models)
Single
radiant
surface
control
Fig. 1
Dual
radiant
surface
control
(some models)
¢ookware
material
types
The cookware material determines how evenly and quickly
heat is transferred from the surface element to the pan
bottom. The most popular materials available are:
Aluminum = Excellent heat conductor. Some types of food
will cause it to darken (Anodized aluminum cookware
resists staining & pitting). If aluminum pans slide across the
ceramic cooktop, they may leave metal marks which will
resemble scratches. Remove these marks immediately.
Copper = Excellent heat conductor but discolors easily. May
leave metal marks on ceramic glass (see Aluminum).
Stainless
=Slow heat conductor with uneven cooking
results. Is durable, easy to clean and resists staining.
Cast Iron =A slow heat conductor however will retain heat
very well. Cooks evenly once cooking temperature
is
reached. Not recommended for use on ceramic cooktops.
Porcelain=enamel
on metal =Heating characteristics will
vary depending on base material. Porcelain=enamel coating
must be smooth to avoid scratching ceramic cooktops.
Glass = Slow heat conductor. Not recommended for
ceramic cooktop surfaces because it may scratch the glass.
Using proper cookware
The size and type ofcookware used will influence the
setting needed for best cooking results. Be sure to follow
the recommendations
for using proper cookware as
illustrated in Figs. 2 & 3.
Cookware should have flat bottoms that make good contact
with the entire surface heating element (See Fig. 2). Check
for flatness by rotating a ruler across the bottom of the
cookware (See Fig. 3). For more information about the
ceramic cooktop see"Cooktop cleaning & maintenance" in
the Care &Cleaning
section.
®
o
%
.....
t
t
® Curved and warped pan.
Flat bottom and straight
sides.
Tight fitting lids.
Weight of handle does
not tilt pan. Pan is well
balanced.
• Pan larger than cooking area
marked on cooktopby more
thanone-half i nch or 12mm.
• Pan sizes match the
amount of food to be
prepared and the size of
• Heavy handle tilts pan.
the surface element.
® Made of a material that
conducts heat well.
• Easy to clean.
® Pan is smaller or larger
o Always match pot
than heating area marked
diameter to element size.
on cooktop.
Fig. 2
Fig. 3
Advertisement
Table of Contents
