Kenmore 790.9661 Series Use & Care Manual page 30

Setting Warmer Drawer Controls
• Warmer Drawer Indicator Light
• Removing & Replacing Warmer Drawer
Left Glide
Warmer (Warm & Ready
TM)
Drawer _ndicator Light (some
models)
The indicator light is located above the Warmer Drawer thermostat control. It
turns on when the control is set, and stays on until the control is turned OFF.
The warmer drawer is inoperable during the Self-Clean cycle. The indicator light
will not come on during the Self-Clean cycle.
Remove shieRd on righ
glide, Pull up on Ueft Uever
while pushing down on
right Ueven
Push do\_'n with finger
Fig. 1
NOTE: The Warmer Drawer wil! NOT
operate whi!e in the Se!fTC!ean and
!!Oven Lockout'! modes
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
To Remove and Replace Warmer (Warm & Ready
TM)
Drawer
(some models)
To Remove Warmer Drawer:
1. _ Turn power OFF before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hexzhead screw
(See Fig. 1). Use a 1/4" socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide (See Fig. 2).
3. Align the glide on each side of the drawer with the glide slots on the range.
4. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 2-4. This will minimize possible
damage to the bearing glides.
3O