Before Setting Oven Controls; Setting Surface Controls - Kenmore 790.61750 Use & Care Manual

Hide thumbs Also See for 790.61750:
Table of Contents

Advertisement

Before Setting Oven Controls
OVEN VENT LOCATED
UNDER LEFT REAR ELEMENT
Oven Vent Location
For models equipped with coiled surface elements, the oven vent is located under
the left rear surface element.
When the oven is on, warm air flows through the
left rear element. This venting is necessary for proper air circulation in the oven
and good baking results. DO NOT BLOCK THE OVEN VENT.
Arranging
Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN). Always use oven mitts when using the oven.
Removing
& Replacing
Oven Racks
To remove,
pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide the rack back into place.
Rack
RECOMMENDED
RACK POSITIONS
FOR
BROILING,
BAKING & ROASTING
Food
Rack Position
Broiling meats, chicken or fish
1,2 or 3
Cookies, cakes, pies, biscuits & muffins
3 or 4
Frozen pies, angel food cake, yeast, bread,
5
casseroles, small cuts of meat or poultry
Turkey, roast or ham
6
Setting Surface Controls
To Operate
the Surface
Elements:
1.
Place cooking utensil on the surface element.
2.
Push in and turn the surface control knob in either direction to the desired setting. Start most cooking operations on a higher
setting and then turn to a lower setting to finish cooking. The control knobs do not have to be set exactly on a particular
setting. Use the settings as a guide and adjust the control knob as needed.
3.
When cooking is completed, turn the surface element offbefore removing the pan. Note: The surface"Element
On" indicator
light(s) will glowwhen one or more elements are turned on. A quickglance atthese indicator light(s) when cooking isfinished
is an easy check to be sure all surface elements are turned off.
The suggested settings found in the chart below are based on cooking in medium-weight
_L_r
eN
aluminum pans with lids. Settings may vary when using other types of pans.
O
SURFACE ELEMENTS
1
2
OFF
Setting
Type of Cooking
HIGH (HI _9)
Hm
MEDIUM HIGH (7- 8)
g
MEDIUM (5 _ 6)
8
MEDIUM LOW (2 _ 4)
Start most foods, bring water to a boil, pan broiling
Continue a rapid boil, fry, deep fat fry
Maintain a slow boil, thicken sauces and gravies, steam vegetables
Keep foods cooking, poach, stew
LOW (LO - 1)
Keep warm, melt, simmer
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top
of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed
too close to the surface elements.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.61751790.61752790.61754

Table of Contents