Materials And Basic Tools Needed; Materials Needed; B_Sic Tools - Kenmore 153.334590 Owner's Manual

Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parrs shown below. You may or may not need all of these materi-
als, depending on your type of installation.
WATER HEATER INSTAL-
LATION KIT WITH FLEXI-
BLE CONNECTORS FOR
314" OR liT' THREADED
OR COPPER PLUMBING
VENT ELBOW
EXPANSION TANKS
FOR THERMAL
EXPANSION CONDI-
TIONS AVAILABLE IN
2 GALLON AND 5
GALLON CAPACITY
THROUGH LOCAL
SEARS STORE OR
SERVICE CENTERS
VENT PiPE
I
FLEXIBLE WATER
HEATER GAS CON-
NECTORWITH
FITTINGS
WATER HEATER STAND 24"x24"x18"
FOR USE WITH WATER HEATERS
INSTALLED IN RESIDENTIAL
GARAGES HAVING A DIAMETER 24"
OR LESS AND A RATED CAPACITY
75 GALLONS OR LESS
DRAIN PANS AVAILABLE IN 20" DIAME-
TER FOR WATER HEATERS HAVING A
WATER HEATER HEAT DIAMETER 18" OR LESS AND AVAIL-
TRAPS HELP REDUCE HEAT ABLE IN 28" DIAMETER FOR WATER
LOSS DUE TO THERMAL HEATERS HAVING A DIAMETER 26" OR
SYPHONING LESS
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
• Pipe Wrenches (2) 14"
• Screwdriver
• Tin Snips
• 6 Foot Tape of Folding Rule
• Garden Hose
• Drill
• Pipe dope or Teflon Tape
GARDEN HOSE 6 FOOT TAPE
SLOT-HEAD SCREWDRIVER
PIPE
WRENCH
PHILLIPS SCRE_NDRIVER
TIN SNIPS
ROLL OF TEFLON TAPE _L_J_ | [Jl
(USE ONLY ON WATER
CONNECTIONS) DRILL
PIPE DOPE (SQUEEZE TUBE)
(USE FOR WATER AND
GAS CONNECTIONS)
ADDITIONAL TOOLS NEEDED
WHEN SWEAT SOLDERING
• Tubing Cutters or Hacksaw
• Propane Torch
• Sof_ Solder
• Solder Flux
• Emery Cloth
• Wire Brushes
HACKSAW
314" WIRE BRUSH
112" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
ROLL OF EMERY
CLOTH SOLDER FLUX
\
PROPANE
TORCH
TUBING
CUTTER