Kenmore 116.32923 Owner's Manual page 17

ili!ililiiii!ilili!ii!i!i!ii!!i i!!!!!!iii!iiiiliiiiiii! iil i iiiiill i i iiiiiiiiii iil i i_ii!_i_i_iiiii_!_i_! i_!_!_!_i_ii!_!iiiiii_i;i_ili iUi iii_i_i_iii_i_i_i_iiiii ili_i_ili i_i;i_!_!_!_i_!_;!_!_!;!_i_i_! ii!_!_!_iiii!_i !_U_i_ii_ii_iii_iii_iiiiiiiiiiiiii!iiiiiiiiiiiii!iii
._1 WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
TO REMOVE LIGHT BULB
Disconnect power cord from electrical out-
let.
Pry light lens
out at slot in
rear as shown
on both sides.
Rotate lens up
and lift off.
Slots
CAUTION
Do not use a bulb rated over 9W
(13V). During extended use, heat
from the bulb could overheat sur-
rounding plastic parts.
Remove the
light bulb by
pulling
straight out.
To Release
To replace
the light bulb,
carefully
insert fully
into slot.
Note: See PARTS AND FEATURES for
bulb number.
._ CAUTION
Do not plug in or turn on until the
vacuum is completely reassembled.
To replace light
lens, place tabs
at front of lens
into slots. Rotate
lens down and
snap into place.
To maintain efficient cleaning, the agitator
must be kept free of carpet pile, stdng, or
hair build-up. After every 7 to 10 uses,
unplug and turn vacuum over and check
agitator for stdng and hair build-up.
Use a scissors to remove any build-up
entangled around the agitator.
17