Kenmore 116.32921 Owner's Manual page 5

Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete_
Failure to do so could result in elec-
trical shock or injury,
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List° Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
Remove tape from filter cover and dust bin
latch.
HANDLE ASSEMBLY
Remove the two (2) handle screws located
in the body,
Position the handle as shown in the illustra-
tion below,
When installing the handle, firmly press the
handle onto the body. Secure with handle
screws provided°
Handle
Screw_.__~
Handle
"_----" Handle
Screw
I
Electricat_ I
Connection _'_,,_i_ _ _ Tape
I ' Note: Do Not
t ,_i_ Remove Tape
_ _.1_aody
5
CAUTION
Do not overtighten handle screws.
Overtightening could strip the
screw holes.
Do not operate the cleaner with-
out the screws in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position Remove
the wire tie from the power cord.
Lock the cord into Lockin
place by forcing it
into the locking
notch on the body of
the quick release
upper cord hook as
shown This helps Power
keep the power cord Cord
out from under the
vacuum cleaner agi-
tator.
Power
Co,
Lower
Cord
Hook
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord