Amana NTW4501XQ0 Use And Care Manual page 8

Select LOAD SiZE
LOADSIZE
Medium
Small
Large
9, Select options, if desired
EXTRAR|HSE FABR|CSOFTENER
Off On Off On
Select the Load Size setting most suitable for your load. Small
will add a low amount of water for smaller loads and Large
will add the most amount of water for large or bulky loads.
Garments need to move freely.
If you want to add an Extra Rinse to the cycle, be sure to set
the Extra Rinse option knob to ON. If you are using fabric
softener, be sure to set the Fabric Softener option knob to ON.
Select WASH TEMPERATURE
WASHTEMPERATURE
All Cold Rinses
Cool Warm
Cold
Hot
Once you select a cycle, select the desired temperature by
turning the Wash Temperature knob to the appropriate setting
based on your load. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
i_ ......................................................................................................................................................................................................................................................... iii . .....................................................................................................
: Wash Temperature Suggested Fabrics
: Hot
::i Some cold water is added to save
::i energy. This will be cooler than
: your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Whites and pastels
Durable garments
Bright colors
Moderate to light soils
cool iii
Warm water may be added to Colors that bleed
assist in soil removal and to help or fade
dissolve detergents. Light soils
Cold
This is the temperature from your Dark colors that
faucet. If your tap cold water is bleed or fade
very cold, warm water may be Light soils
added to assist in soil removal
and help dissolve detergent.
Press START/PAUSE/U NLOCK
to begin wash cycle
START
Pause/Unlock
©
Hold 3 Sec
to Cancel
Press the START/PAUSE/UNLOCK button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the DONE indicator
will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/UNLOCK; the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/PAUSE/UNLOCK again to restart
the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.
8