you call for service,
review this list. It may save you time and expense. The list includes common
that are not the result of defective workmanship
in this appliance,
Surface burners do
Surface Control knob has not been completely turned to LITE. Push in and turn the Surface
Control knob to LITE until burner ignites and then turn control to desired flame size.
Be sure gas supply valve is open.
Gas-air mixture needs a straight
line to travel.
Be sure burner is properly seated in its
Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to
clean ports or slots.
Power cord is disconnected from outlet (electric ignition models). Be sure cord is plugged
securely into outlet.
Electrical power outage (electric ignition models). Burners can be lit manually. See Setting
Surface Controls in this Owner's Guide.
Burner ports or slots are clogged. With the burner off, clean ports with a small-gauge wire
burns half way
or needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame
is full. Dry the burners thoroughly following instructions under General Cleaning.
Surface burner flame
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
In coastal areas, a slightly orange flame is unavoidable due to salt air.