Frigidaire CGEF3032MFA Use & Care Manual page 33

Problem Possible Causes
Oven portion of Incorrect oven control setting.
appliance does not
operate.
Entire appliance does
not operate.
Solutions
Be sure the oven control was set correctly for the requested
feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or see
"Entire appliance does not operate" in this checklist.
Lock feature set (some models). Cancel the lock feature (some models).
Power supply to appliance Be sure appliance power cord is plugged properly to electrical
disconnected or electrical outlet. Check house circuit breaker; reset if needed. If the electric
power outage, service to the house is out, call your local electric utility for
service.
Service wiring is incomplete. Contact your dealer, installing agent or authorized service agent
for assistance.
Range is not level. Floor is not level, weak or If floor under range is sagging or sloping, contact a carpenter to
unstable, correct the problem.
The cooktop or oven racks are To correct, place oven rack in center of oven. Place a bubble (or
not level, spirit) level centered on the oven rack. Adjust by turning leveling
legs at bottom of range until the oven rack rests level.
Cabinet alignment may make Be sure kitchen cabinets are square & have sufficient room for
range appear not level, appliance clearance.
Cannot move Carpet interferes with range. Provide sufficient space so appliance may be lifted over carpet.
appliance easily. ..............................................................................................................................................................................................
Appliance must be Cabinets are built in too tightly Contact builder or installer to make appliance accessible.
accessible for to appliance sides.
service.
________ ________________________________________________________________________________________________________________________________________ _______________________________________________________________________________________________
Quick bake fan makes The quick bake fan may turn This is normal. On some cooking features the convection fan may
noise. ON or OFF automatically, run until the feature is done or the door was opened or closed.
Quick bake fan turns Oven door is open. The quick bake fan will turn OFF if the oven door is opened while
ON and OFF while quick bake feature is active. Close oven door.
cooking.
Quick bake fan turns For some models the quick This is normal (some models).
on with features that bake fan may turn ON while
should run without a preheating.
fan (some models).
Oven control displays The probe is not fully inserted Double check that the probe is fully inserted into probe
"PErr". The probe is into the probe receptacle, receptacle. Use only the probe originally supplied with range.
not recognized by the ..............................................................................................................................................................................................
oven control. Probe has overheated. Remove the probe from the receptacle, then reconnect probe into
the receptacle (check that it is fully inserted into the receptacle).
Be sure the probe sensor is covered by food and not exposed to
avoid overheating.
If the error code remains, the Remove the probe from receptacle and oven. The oven may still
probe may be damaged or the be used normally without the probe. Call your authorized service
probe cable has a short, agent for assistance.