Troubleshooting - Jenn-Air JBC2088HTQ Use & Care Manual

12828122 Jenn-Air BF Eng 1/14/05 9:04 AM Page 31
TROUBLESHOOTING
Ice and Water
Refrigerator is Plastic tubing was used to complete Tile manufacturer recommends using copper tubing
leaking water water connection, for installation. Plastic is less durable and can cause
Improper water valve was installed.
Ice forms in inlet
tube to ice maker
Water pressure is low.
Water flow is
slower than normal
Freezer temperature is too high.
Water pressure is low.
Improper water valve was installed.
Copper tubing has kinks.
Water filter is clogged or needs to be
changed.
leakage. The manufacturer is not responsible for
property damage due to improper installation or
water connection.
Check water connection procedure (:seepage 9]. Self-
piercing and _/:6" saddle valves cause low water
pressure and may clog the line over time. The
manufacturer is not responsible for property
damage due to improper installation or water
connection.
Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Adjust freezer control (:seepages 10-12]. Freezer is
recommended to be approximately 0° F (:-18 ° C].
Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Check water connection procedure (:seepage 9]. Self-
piercing and _" saddle valves cause low water The
manufacturer is not responsible for property
damage due to improper installation or water
connection.
Turn off water supply and remove kinks. If kinks
cannot be removed, replace tubing.
Change water filter (:seepage 17].
3O