Loading - Jenn-Air JDB1080AW Use & Care Manual

G
Operating the Dishwasher
(Modems with cycle selector knob)
1. After loading the dishwasher and adding
detergent, select the desired cycle by turning the
cycle selector knob. Select options by pressing the
buttons. The indicator lights for the options will
illuminate. To cancel an option, press that button
again.
2. To start a cycle, close the door until it latches then
press the START button once. After a pause, the
fill will begin.
If START is not pressed within 30 seconds of
choosing your cycle, the dishwasher will turn off.
To prevent unplanned cycle or option changes,
these selections are "locked in" after one minute.
3. To cancel a running cycle, turn the cycle selector
knob to Drain/OFF. The dishwasher will drain,
then shut off. To turn the dishwasher off without
draining, turn the cycle selector knob to Drain/
OFF then press the START button once.
Adding a Forgotten item
For best cleaning, the forgotten item should be added
early in the cycle.
1, Grasp door handle and unlatch door without
opening completely. All lights will flash to indicate
that the cycle is suspended.
2. Wait for the water circulation to stop.
3, Open the door and add the item.
4.
Close and latch the door. Lights will stop flashing
when the door is properly shut. After a slight
delay, the cycle resumes automatically at the point
of interruption.
If the door is opened during a running cycle,
there may be up to a 30 second delay before the
dishwasher restarts after dosing the door.
Extended interruption of the wash cycle is not
recommended.
General Recommendations
(Rack features vary by model)
. Items can be centered behind a single tine or loaded
at an angle to maximize space.
Avoid blocking or preventing the spray arms from
spinning freely. Do not allow items to extend beyond
the racks.
Face soiled surfaces toward the center of the
dishwasher.
For best dishwashing results follow guidelines on
following pages to determine the best arrangement for
your items.