Operating Tips - Jenn-Air JDB1080AW Use & Care Manual

Before You Start
. Don't prerinse° Simply scrape off any bones or
large food particles°
. If connected to a food waste disposer, make certain
the disposer is empty before starting the
dishwasher.
. Scrape off tomato-based food soims (see page 15).
. Remove certain foods such as mustard,
mayonnaise, lemon juice, vinegar, salt or dressings
from stainless steel flatware as soon as
possibme. These foods may cause rusting and pitting
if allowed to remain in contact with the surface for
an extended period of time.
Operating the Dishwasher
(Modems with front or combination front and
top touchpad controms)
1. After loading the dishwasher and adding
detergent, select the desired cycle and options by
pressing the pads. The indicator lights for the
selected cycle and options will ilhminate. To cancel
an option press the pad again.
2. To start a cycle, close the door until it latches then
press the START/Cancel pad once. After a pause,
the fiI[ w[[[ begin. The display countdown (select
models) wi[[ flash until START!Cancel is pressed.
. If START/Cancem is not pressed within 30
seconds of choosing your cycle, the dishwasher
will turn off.
To prevent unplanned cycle or option changes,
these selections are "locked in" after 1 minute.
The dishwasher remembers your last cycle so you
do not have to reset the cycle each time. To start
the dishwasher using the same cycle and options
selected on the previous wash, just press the
START!Cancel pad.
3. To cancel a running cycle, press the START/
Cancel pad once. The dishwasher will drain, then
shut off. To turn the dishwasher off without
draining, press the START/Cancel pad twice.
Operating the Dishwasher
(Models with top only touchpad controls)
1. After loading the dishwasher and adding
detergent, select the desired cycle and options by
pressing the pads. The indicator lights for the
selected cycle and options will ilhminate. To cancel
an option press the pad again.
2_
To start a cycle, press the START/Cancel pad
once. The indicator light will illuminate. Close the
door until it latches. After a pause, the fill will
begin.
3_
If START/Cancel isnot pressed within 30
seconds of choosing your cycle, the dishwasher
will turn off.
To prevent unplanned cycle or option changes,
these selections are "locked in" after 1 minute.
The dishwasher remembers your last cycle so you
do not have to reset the cycle each time. To start
the dishwasher using the same cycle and options
selected on the previous wash, just press the
START/OanceI pad.
To cancel a running cycle, carefully unlatch the
door without opening completely and wait for
water circulation to stop. Press the START!
Cancel pad once and then shut the door. The
dishwasher will drain, then shut off. To turn the
dishwasher off without draining, press the
START!Cancel pad twice and then shut the door.
. If a cycle pad is pressed after the controls have
been "locked in", the light above the current cycle
will flash three times.
Cont.
If a cycle pad is pressed after the controls have
been "locked in", the light above the current cycle
will flash three times.
2