Advertisement
Available languages
Available languages
TEM PERATU RE CONTROLS
Trisensor Climate Control
(select
models)
The control is located at the top front of the fresh food
compartment.
Control
_JENN-A[R
Initial Temperature
Setting
Temperatures
are preset at the factory at 38 ° F (3° C)
in the fresh food compartment
and 0° F (-17 ° C) in the
freezer compartment.
Adjusting
the Control
24 hours after adding food, you may decide that one or
both compartments
should be colder or warmer.
If so,
adjust the control as indicated in the Temperature
Control Guide below.
• The first touch of the •
or •
pads shows the
current temperature
setting.
• The display will show the new setting for
approximately
three seconds, and then return to the
actual temperature
currently within that
compartment.
• Do not change either control more than one degree
at a time.
Allow temperature
to stabilize for 24 hours
before making a new temperature
adjustment.
Temperature
Control Guide
Refrigerator
too cold
Refrigerator
too warm
Freezer too cold
Freezer too warm
Turn refrigerator
OFF
Set the Refrigerator
control
to next higher number by
pressing the •
pad.
Set the Refrigerator
control
to next lower number by
pressing the •
pad.
Set the Freezer control to
next higher number by
pressing the •
pad.
Set the Freezer control to
next lower number by
pressing the •
pad.
Press the Freezer
•
pad
until OFF appears in the
display.
Press either the
Freezer or Refrigerator
•
pad to turn back on.
Speed Ice
When activated, Speed Ice reduces the freezer
temperature
to the optimum
setting for 2/4 hours in
order to produce more ice. Important:
When the
Speed Ice feature is in operation, the
•
and •
pads
for the Freezer control will not operate.
Reset Filter (select
models)
When a water filter has been installed in the
refrigerator,
the yellow Order light will illuminate when
900/0 of the volume of water for which the filter is
rated has passed through the filter OR 11 months have
elapsed since the filter has been installed.
The red Replace light will illuminate
when the rated
volume of water has passed through
the filter OR 12
months have elapsed since the filter was installed.
A
new filter should be installed immediately
when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset
Filter pad for three seconds.
The Order and Replace
lights will go off.
Vacation
Mode
The Vacation Mode feature causes the freezer to
defrost less frequently, conserving
energy. The
Vacation Mode indicator
light will illuminate when the
feature is activated.
To deactivate, press the Vacation
Mode
pad again OR open either door. The indicator
light will go out.
Notes
:
• Door openings will not deactivate Vacation Mode
for approximately
one hour after activation.
• If vacationing
for more than a few days, see the
Preparing for Vacation section, page 28.
Temp Alarm
The Temp Alarm system will alert you if the freezer or
fresh food temperatures
exceed normal operating
temperatures
due to a power outage or other event.
When activated, the Temp Alarm light will illuminate.
If the freezer or fresh food temperatures
have
exceeded these limits, the display will alternately
show
the current compartment
temperatures
and the highest
compartment
temperatures
reached when the power
was out. An audible alarm will sound repeatedly.
Cont.
10
Advertisement
Chapters
Troubleshooting
