Setup Procedure - LG BNU-BAC Owner's Manual

(2) Network environment setup of the BACnet Gateway
• After getting the IP address of the BACnet Gateway assigned from the network administrator, use
the button of the BACnet Gateway to set up the IP address and the network environment of the
BACnet Gateway.
I Setup procedure
• Set the IP address
• Enter the Gateway address
• Enter the net mask
• Check the network environment setting
Note: If the above items are not entered, it is impossible to control the BACnet Gateway or it causes
the communication error, so make sure that all of them are correctly entered.
1. Setting the IP address
First, press the "MENU/SELECT" button of the BACnet Gateway. When the following menu is
displayed on the BACnet Gateway LCD screen, press the "MENU/SELECT" button again to enter
the IP address.
MENU/
SELECT
Use the up/down/left/right button ( , , , ) to select the desired address.
MENU/
SELECT
After entering the last address, press the "MENU/SELECT" button to set the entered address to the
IP address. (When there is no "MENU/SELECT" button input for 5 seconds, the set value is ignored
to return to the existing address.
MENU/
SELECT
[LCD screen]
[MENU]
Set IP address
[Example for setting the gateway address]
[Set IP address]
165.186.002.101
[LCD screen after completing the setup]
BACnet Gateway
SW ver. 1.0.0
How to install
[Set IP address]
192.168.000.000
Installation/Owner Manual 25