Inglis series 355 Use & Care Manual page 22

PROBLEM CAUSE SOLUTION
Spotting
and Incorrect amount
filming of detergent
(continued)
Dishes do not
dry completely
Use of ineffective
detergents
Insufficient fill due to
low water pressure
Dishes do not drain
properly
Plastics
Follow recommendations for amount. Heavy
soil and/or hard water generally require
extra detergent.
Use fresh detergent. Store detergent
tightly closed in a cool, dry place. Discard
lumpy detergent.
Home water pressure should be 20 to 120
psi (138 to 828 kPa) for proper dishwasher
fill. A booster pump on the water supply
may be necessary if pressure is too low.
Dishes must have proper water drainage.
Do not overload. See the "Loading Your
Dishwasher" section. Use a liquid rinse
agent to speed draining.
NOTE: In some cases, loads may not dry
as well when using Hi-Temp Wash.
Some plastics, due to material, may need to
be towel dried.
Silica film or
etching
(silica film is a
milky, rainbow-
colored deposit;
etching is a
cloudy film)
Black or gray
marks on dishes
Water chemical
reaction with certain
types of glassware -
usually caused by
some combination of
soft or softened water,
alkaline washing
solutions, insufficient
rinsing, overloading the
dishwasher, and heat
of drying.
Aluminum items
touching dishes
It may not be possible to prevent problem,
except by hand washing. To slow this pro-
cess, use a minimum amount of detergent
but not less than 1 tablespoon (15 mL) per
load. Use a liquid rinse agent and under-
load the dishwasher to allow thorough
rinsing. Silica film and etching are perma-
nent and cannot be removed. Use the Air
Dry option.
Load aluminum items so that they will not
rub against dishes during washing. Do not
wash throwaway aluminum items in the
dishwasher because they may break down
and cause marking. Remove aluminum
markings by using a mild abrasive cleanser.
White spots on Seasoning removed by Reseason cookware after dishwasher
cookware with dishwasher detergents washing.
non-stick finish
22