Mowing Tips; Level Mower - Husqvarna LOGTH2448T Operator's Manual

4_ Move motion control lever to full
forward position and hold for five (5)
seconds_ Move lever to full reverse
position and hold for five (5) seconds.
Repeat this procedure three (3) times.
5. Move motion control lever to neutral
(N) position. Shutoff engine and set
parking brake.
6. Engage transmission by placing free-
wheel control in engaged position (See
"TO TRANSPORT" in this section of
manual).
7. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to half (1/2) speed_
With motion control lever in neutral (N)
position, slowly disengage clutch/brake
pedal.
8. Slowly move motion control lever for-
ward, after the tractor moves approxi-
mately five (5) feet, slowly move motion
control lever to reverse position. After
the tractor moves approximately five
(5) feet return the motion control lever
to the neutral (N) position. Repeat this
procedure with the motion control lever
three (3) times°
Your transmission is now purged and now
ready for normal operation.
MOWiNGTIPS
• Tire chains cannot be used when tile
mower housing is attached to tractor.
° Mower should be properly leveled for
best mowing performance° See "TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
° The left hand side of mower should be
used for trimming.
° Drive so that clippings are discharged
onto the area that has already been
cut° Have the cut area to the right of
the tractor'. This will result in a more
even distribution of clippings and more
uniform cutting.
• When mowing large areas, start by
turning to the right so that clippings will
discharge away from shrubs, fences,
driveways, etc. After one or two rounds,
mow in the opposite direction making
left hand turns until finished o
f m,,,_
• If grass is extremely tall, it should be
mowed twice to reduce load and pos-
sible fire hazard from dried clippings.
Make first cut relatively high; the second
to the desired heighL
o Do not mow grass when it is wet.
Wet grass wilt plug mower and leave
undesirable clumps. Allow grass to dry
before mowing.
° Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material° Regulate ground speed by
selecting a low enough speed to give
the mower cutting performance as well
as the quality of cut desired.
o When operating attachments, select a
ground speed that will suit the terrain
and give best performance of the at-
tachment being used,
15