Husqvarna LOGTH2448T Operator's Manual page 6

Slope Sheet
Keys
qlll',l
(2) Keys
(1) Oil Drain Tube
For Future Use
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes.
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posF
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Cut along dashed lines on all four pan-
els of carton° Remove end panels and
lay side panels flat,
2, Remove protective materials from trac-
tor hood and grille,
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to ro!l off skid
CHECK BATTERY
!, Lift hood to raised position.
NOTE: if this battery is put into service
after month and year indicated on label
(L) (label is located between terminals)
charge battery for minimum of one hour at
6-10 amp& (See "BATTERY" in Mainte-
nance section of this manual for charging
instructions)
ADJUST SEAT
1, Sit in seat.
2. Lift up adjustment lever (A) and slide
seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
3. Release lever to lock seat in position°
6
NOTE: You may now roll or drive your
tractor off the skid Follow the appropriate
instruction below to remove the tractor
from the skid,
WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a welkventilated area. Be sure
the area in front of tractor is clear of other
people and objects°
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of
controls)
1. Raise attachment lift lever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in "trans-
mission disengaged position" (See "TO
TRANSPORT" in the Operation section
of this manual).