Advertisement
Foreaseof mower t o tractorassembly, raisegauge
wheels to highest p osition andretain withclevispins
andspringretainers.
Adjust g auge wheels before operating m ower. See"TO
ADJUST GAUGE WHEELS" inthe Operation s ection
ofthismanual.
3/8WASHER
318-16 CENTER
LOCKNUT
FIG. 5
_NSTALL MOWER
AND DR_VE BELT
(See Figs. 6 and 7)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage park-
ing brake.
•
Cut and remove ties securing anti-sway bar and belts.
Swing anti-sway bar to left side of mower deck.
•
Slide mower under tractor with deflector shield to right
side of tractor.
IMPORTANT:
Check belt for proper routing in all mower
pulley grooves.
•
if equipped,
turn height adjustment
knob counter-
clockwise until it stops.
•
Lower mower linkage with attachment lift control.
•
Install belt into electric clutch pulley groove.
•
Place the suspension arms on outward pointing deck
pins. Retain with double loop retainer spring with loops
up as shown.
•
Install front plate assembly
to tractor
suspension
brackets and retain with single loop retainer springs
as shown.
•
Position front plate assembly between front mower
brackets. Raise deck and plate assembly to align holes
and insert flanged pins. Secure pins with double loop
retainer springs between the plate and mower brack-
ets.
NOTE: To assist in locating hole in flanged pin, the hoJe in
pin is inline with notch on head of pin. If necessary, move
mower side-to-side to give space between plate and mower
brackets.
IMPORTANT:
Check belt for proper routing in all mower
pulley grooves.
•
Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
•
If equipped, turn height adjustment knob clockwise to
remove slack from mower suspension.
•
Raise deck to highest position.
•
Adjust gauge wheels before operating mower as shown
in the Operation section of this manual.
ELECTRIC
BRACKETS
CHASSIS
FRONT
CLUTCH
PULLEY
BRACKET
MOWER
BRACKET
ASSEMBLY
_AUGE
_HEEL
\
SINGLE
LOOP
RETABNER
SPRBNGS
DOUBLE LOOP
RETAINER SPR_NG
ANTI-SWAY
BAR
USE PUERS FOR
RETAINER
SPRBNGS
UP
SUSPENSION
ARMS
DOUBLELOOPRETAmNER
SPR_NG(OUTWARDPOINTING
DECK PINS)
DEFLECTOR
SHELD
FIG. 6
8
Advertisement
Troubleshooting
