Advertisement
_NSTALLSEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•
Remove adjustment
knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
•
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
•
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
•
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
•
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable
position is reached
which allows you to press clutch!brake pedal all the
way down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment knob securely.
SHOULDER
BO_
SEAT
FLAT WASHER
ADJUSTMENT
KNOB
FIG. 3
NOTE: You may now rolJ or drive your tractor off the skid.
Follow the appropriate
instruction below to remove the
tractor from the skid.
TO ROLL
TRACTOR
OFF
SKmD (See
Op-
eration
section
for _ocation
and function
of
controls}
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Release parking brake by depressing
clutch/brake
pedal.
•
Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT"
in the Operation
section of this manual).
•
Roll tractor forward off skid.
TO DRmVE TRACTOR
OFF
SKID
(See
Op-
eration
section
for _ocation
and function
of
controls}
_k WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a weGventilated area. Be sure the area in
front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Place freewheel
control in "transmission
engaged"
position (see "TO TRANSPORT" in Operation section
of this manual).
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
•
Place motion control lever in neutral (N) position.
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Start the engine.After engine has started, move throttle
control to idle position.
•
Release parking brake.
•
Slowly move the motion control lever forward and slowly
drive tractor off skid.
•
Apply brake to stop tractor, set parking brake and place
motion control lever in neutral position.
•
Turn ignition key to "STOP" position.
Continue with the instructions that follow.
TO ATTACH
NOSE ROLLER
(See Fig. 4)
o
Assemble brackets "A" and "B" to the inside of mower
mounting brackets as shown. Tighten securely.
NOTE:
Be sure bracket tabs are positioned in tab holes
in mower brackets.
•
Position nose roller between brackets and install rod
and retainer spring.
HE×
ROD
LOCK
BO_
7
FIG. 4
ASSEMBLE
GAUGE
WHEELS
TO MOWER
DECK (See Fig. 5)
The gauge wheels are designed to keep the mower deck
in proper position when operating mower. Be sure they
are properly adjusted to ensure optimum mower perfor-
mance.
•
Slide gauge wheel bar down into bracket channel, Be
sure that gauge wheel bar aligning holes are on top.
Assemble gauge wheels as shown using shoulder bolts,
3/8 washers and 3/8o16 center locknuts and tighten
securely.
Advertisement
Troubleshooting
