Table of Contents
Advertisement
USING YOUR REMOTE
TO CONTROL ADDITIONAL AUDIO EQUIPMENT
Operating the precoded function for your Audio component.
This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system
of your Audio component (refer to pages 36-37 for pre-codes).
1.
Turn ON your Audio component you wish to control with the Remote,
2.
Aim the remote control at the front of your Audio component.
3.
To switch to Audio (AMP) component pre-ceded mode, use the SOURCE ACCESS buttons (41, b.) on the remote control to posi-
tion the LED light to the correspondingselection.
4.
Hold down the ENT button on the remote and enter the four digit preset code that matches your Audio component, as shown on
pages 36-37. Release the ENT button. The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the Audio component and press the POWER button. The remote will turn off your Audio component when the
correct four digit preset code is entered. When this occurs, the remote control is programmed for your Audio component.
If the
Audio component does not turn off, try a different four digit preset code.
6.
i i_i_i_ii_i
i _i!
iiiii iiiiii°
!ii_i_iiiii
IIM
The remote will now control your Audio component.
Repeat steps 1 - 6 if you wish to program the remote to control another Audio component.
NOTES:
1,
If your Audio component cannot be operated after
performing
the
above
procedures,
your
Audio
component's code has not been preceded into the
remote.
2.
In the unlikely event that your Audio component cannotbe
operated after performing the above procedures, please
consult your Audio equipment operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control.
After replacing the betteries repeat the
entire programming procedure as stated above.
4.
CD precede library is included in the AMP mode. Default
device for this mode is Hitachi Audio/Video Receiver
(AVR/AMP).
5.
INPUTS, Channel (up/down), Volume (up/down)and REC
button are not for CD devices.
(_} PRECODED AUDIO Buttons
These buttonstransmit the chosen preceded Audio
component cedes.
(_
EXCLUSIVE TV Buttons
These buttonsare for operating the "IV.
_
mm_sm_
0
o
o
o
o
Q
-© ©
D D--.:i
=, •
•
, ,_v
'
i
ie ® ®:,
HITACHI
-@
-@
I MY AUDIO EQUIPMENT
CODE IS:
CD
AMP/RCVR
NOTES:
1.
The REC (Record) button only applies to some preceded amplifier/receivercodes.
2.
Refer to instructionmanual of the Audio equipment for operation of the buttonsexclusively for the Audio equipment,
1
34
Advertisement
Table of Contents
