Hitachi UitraVision L42S503 Operating Manual page 12

Quick Setup Guide
Perform the following steps to quickly setup your new
Hitachi LCD Television Set.
1. ANTENNA CONNECTION
Unless your LCD Television is connected to a cable TV system or
to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located
in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufficient.
a). VHF (75-Ohm) antenna/CATV (Cable TV)
When using a 75-Ohm coaxial cable system, connect the CA-R/coaxial
cable to theAIR/CABLE (75-Ohm) terminal. Or if you have an antenna,
connect the coaxial cable to the same AIR/CABLE terminal.
Air/Cable
AIR/CABLE
_oM__ _DM_ 2
Rear Panel Jack
To outdoorAntenna i_r] iL To Antenna
or _ Terminal
Cable TV (CATV)
System
b). VHF (300-Ohm) antenna/UHF antenna
When using a 300-Ohm twin lead from an outdoor antenna, connect
the VHF or UHF antenna leads to screws of the VHF or UHF adapter.
Plug the adapter into the antenna terminal on the TV.
To Antenna
Terminal
Attach an optional antenna cable mixer to the TV antenna terminal
and connect the cables to the antenna mixer. Consult your dealer
or service store for the antenna mixer.
........ ..... _ To outdoor antenna
To UHF antenna | _ _ or CATV system
Antenna Mixer
c). When both VHF and UHF antennas are connected
Connecting a 300-Ohm twin lead connector may cause interference. Using a 75-Ohm coaxial cable is recommended.
2. CONNECT YOUR NEW HITACHI LCD "IV TO THE POWER SOURCE
a). Connect the power cord to your TV set and c). The Indicating Lamp will light red (Standby mode) and
secure it with the AC Wire Clamp (see page 7) . then light blue (image displays).
__! AC Wire Clamp
indicating
Lamp
O 0 POWER
b).
Connect the power cord to the AC wall outlet.
3. POWER ON/OFF YOUR NEW HITACHI LeD TV.
or
Press the POWER button on the Remote Control .....
or the POWER button on the Side Control Panel to []
INPUT
power on/off the LCD TV, For Stand-By []
Power OFF
If the Indicating lamp is OFF, the Power Button on the
Remote Control will not operate. Please make sure
that the power cord is plugged to the AC outlet.
4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE.
12