Hitachi 27CX7B Operating Manual page 27

USING THE REMOTE TO CONTROL
CABLE/SATELLITE BOX FUNCTIONS
Operating the pre-coded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and Digital Satellite Systems. You must first program
the remote to match the remote system in your cable/satellite box. (Refer to page 28.)
1. Turn on your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. Press the CABLE button to switch to cable/satellite box mode.
4. While holding down the CABLE button, enter the 2 digit preset code that matches your cable/satellite box as
shown on page 28. The remote will turn off your cable/satellite box when the correct 2 digit preset code is entered.
When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does
not turn off after 5 seconds, try another 2 digit preset code.
5. The remote will now control your cable/satellite box.
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, this means that your
cable/satellite box code has not been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures,
please consult your cable/satellite box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries, repeat the entire programming procedure stated above.
4. If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.
(_ CABLE Button
This button allows the remote to control your cable/satellite box by setting it to CABLE/SATELLITE mode.
(_ PRECODED BOX Buttons
CABLE/SATELLITE
These buttons transmit the chosen precoded CATV and satellite codes.
(_) TV/VCR Button
When the remote is in CABLE/SATELLITE mode, this is the AJBbutton.
(_ LST-CH Button
If your cable/satellite box has an enter function, this button will send the cable/satellite box enter code.
(_) CSIEXIT/RECALL Button
If your cable/satellite box does not have a last channel function, this button will send the TV channel recall code.
(_ EXCLUSIVE TV Buttons
These buttons are for operatingtheTV.
27