Table of Contents
Advertisement
USING THE GENIUS
REMOTE
TO CONTROL
VCR FUNCTIONS
Operating the pre-coded function for your VCR.
This remote is designed to operate different types of VCR's. You must first programthe remote to match the remote
system of yourVCR. (Refer to page 24.)
1.
Turn ON your VCR.
2.
Aim the remote control at the front of yourVCR.
3,
While holding down the VCR buttonon the remote, enter the 2 digit preset code that matchesyour VCR as shown
on page 24. The remote willturn offyour VCR when the correct 2 digit preset code is entered. When this occurs,
the remote control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different 2
digit preset code.
r
4.
The remote,will now control your VCR.
Q
NOTES:
1.
If your VCR cannot be operated after performing
the above procedures, this means that your VCR's
code has not been precoded into the remote.
2.
In the unlikely,event that yourVCR cannot be oper-
ated after performingthe above procedures, please
consult yourVCR operating guide.
3.
The remote control will remember the codes you
have programmed in until the batteries are
removed from the remote control. After replacing
the batteries repeat the entire programmingproce-
dure stated above.
4.
If your VCR does not have a power function, the
remote will issue the CHANNEL UP function.
5.
The MENU button will act as the VCR MENU but-
ton for HITACHI VCR's.
6.
The EXIT button will act as your VCR ENTER but-
ton if required.
7.
The INPUT button will act as yourVCR +100 button
if required.
(_VCR
button
This button allows the remote to control=your VCR
by setting it to VCR mode.
Q
pRECODED VCR buttons
Q
These buttons transmit the chosen precoded VCR
codes.
(_) EXCLUSIVE TV buttons
These buttonsare for operating the TV.
HITACHI
CLU,.417UI
®
®
22
Advertisement
Table of Contents
