Healthrider S300i User Manual page 10

WARNING: To reduce the risk of
serious injury, read the following precautions
before operating the console.
- Do not stand on the walking belt when turn-
ing on the power or starting the walking belt.
• Always attach the clip (see "H"on page 8) to
your waistband when using the treadmill, if
the key is pulled from the console, the walk-
ing belt will stop.
• The treadmill is capable of high speeds.
Adjust the speed in small increments.
• To reduce the risk of electric shock, keep
liquids away from the console and place only
a sealed water bottle in the console.
HOW TO USE THE MANUAL MODE
nl Insert the key into the console.
See HOW TO TURN ON THE POWER at the left.
Select the manual mode.
When the key is in-
serted, the manual
mode will be selected
and the manual indica-
tor will light. If a pro-
gram has been se-
lected, press the Select
CrossTra_nl_
iOeont
Workout button repeatedly to select the manual
mode.
Do not use the hand weights at speeds higher
than a walk. Using hand weights and not hold-
ing the handrails may compromise your ability
to maintain you r balance. Exercises using
hand weights should be attempted only by ex-
perienced users.
Press the Start button or the Speed button
to start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move at 1.0 mph. Hold the hand-
rails and begin walking.
if you have heart problems, or if you are over
60 years of age and have been inactive, do
not use the pulse programs, if you are taking
medication regularly, consult your physician
to find whether the medication will affect
your exercise heart rate. Note: The pulse pro-
grams require an optional chest pulse sensor.
As you exercise, adjust
the speed of the walking
belt as desired by press-
ing the Speed buttons.
Each time one of the
buttons is pressed, the
speed will change by
0.1 mph. If one of the buttons is held down, the
speed will change in increments of 0.5 mph.
10
HOW TO TURN ON THE POWER
Plug in the power cord (see HOW TO PLUG IN
THE POWER CORD on page 7).
Locate the on/off
switch on the front of
the treadmill near the
power cord. Make
sure that the on/off
switch is in the on
position.
On
Position
Stand on the foot
rails of the treadmill.
Find the clip attached
to the key and slide
the clip onto the
waistband of your
clothing. Next, insert
the key into the console. After a moment, the four
displays and various indicators will light.
To stop the walking belt, press either of the Stop
buttons. The four displays will pause and the
Time/Segment Time display will begin to flash. To
restart the walking belt, press the Start button or
the Speed button. To stop the walking belt and
reset the displays, press a Stop button, remove
the key, and then reinsert the key.
Adjust the incline of the treadmill.
To vary the intensity of
your exercise, adjust the
incline of the treadmill
as desired with the
Incline buttons. Each
time one of the buttons
is pressed, the incline
-J.-2II
m:_ DISTANCE _
will change by 0.5%. The incline range is 1.5% to
10%. Note: After the buttons are pressed, it may
take a moment for the treadmill to reach the se-
lected incline setting.