Transaxle Motion Control Lever Neutral Adjustment; Transmission Removal/Replacement; To Adjust Steering Wheel Alignment; Front Wheel Toe-In/Camber - Husqvarna GTH2548 Owner's Manual

SERVICE AND ADJUSTMENTS
TRANSAXLE MOTION CONTROL LEVER
NEUTRAL ADJUSTMENT (See Fig. 27)
The motion control lever has been preset at the factory and
adjustment should not be necessary.
° Park tractor on level surface. Stop tractor by turning
ignition key to "OFF" position and engage parking
brake.
° Loosen the adjustment bolt in front of the right rear
wheel.
° Move motion control lever to the neutral position (N).
° Tighten the adjustment bolt.
BOLT
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 28)
• Block up axle securely.
° Remove axle cover, retaining ring and washers to allow
wheel removal.
° Repair tire and reassemble.
° Replace washers and snap retaining ring securely in
axle groove.
° Replace axle cover.
REAR WHEEL -
° Block rear axle securely.
° Remove five (5) hub bolts to allow wheel removal.
° Repair tire and reassemble. Replace and tighten hub
bolts securely.
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
FIG. 27
TRANSMISSION REMOVAL/REPLACEMENT
Should your transmission require removal for service or
replacement, it should be purged after reinstallation and
before operating the tractor. See"PU RGETRANSMISSION"
in the Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straightforward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
WASHERS
RETAINING RING
AXLE
COVER
00663
FIG. 28
25