GE RGB740 Owner's Manual & Installation Instructions page 47

ge.com
Possible Causes What To Do
Display goes blank A fuse in your home may be * Replace tile 1use (>r reset tile circuit breaker:
(on some models) blown or the circuit
breaker tripped.
The clock is tnm_ed off so that it * See tile Using the clock and timerse(ti_m.
does not show in the display.
Display flashes
Power failure.
* Reset tile (h wk.
(on some models)
Unable to get the Oven control pads were * Tile BAKE mad BROIL HI/LO pads must be touched at
displayto show "SF" not touched properly, the same time and held fi)_ 3 se(ouds.
(on some models)
Power outage,
Power outage or surge.
* Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFFpad, setting the clock and
(on some models} resettiu,_ any (-()()king tim( ti()u.
"Burning" or "oily" odor
This is normal in a new oven
* To speed
the process,
set a sell:clean cycle fi:,r a
emitting from the vent
and will disappear in thne. minim tuu of 3 houi_.
See the Using the self-cleaning
oven section.
Strong odor An odor from the h_stdation * This is teuq)orzu'y.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan may automatically
* This is uom_al. The cooliu,_ tim will turn off and on.
tttnl on and off to cool
internal parts.
Drawer does not slide The drawer is out of aligmnent.
• Fully extend
the drawer and push it all the way in.
smoothly or drags See the Care and cleaning of the range secfi_)u.
Drawer is over-loaded or load
• Reduce
weight. Redistribt/te drawer c()uteuts.
is unbalanced.
47
iiiiiiiiiiiiiii!!ii _
Iiiii ii i