Shelves - Hotpoint HTS17GCSERWW Owner's Manual And Installation Instructions

Care and cleaning of the refrigerator.
Behind the Refrigerator
Be careful when moving the refl'igerator
away from tile wall. All types of floor
coverings call be damaged, particularly
cushioned coverings and those with
eI//bossed stlr_lces.
Turn tile leveling legs at each fl'ont corner
of tile refligerator counterclockwise tmtil
tile rolle_ support tile ret}'igeratol: Pull tile
refl_igexwtor straight out and return it to
position by pushing it straight in. Moving
tile refl_igemtor in a side direction may
result in damage to tile floor coveting or
refligemtor.
When pushing the refngerator back, make sure
you don't rofl over the power cord or icernaker
supply/1be (on some models).
After rolling tile refl'igerator back into
place, turn tile legs (h)rkwise until tile
legs again bear the weight of the
refi'igerator.
Light Bulb Replacement
To replace a burned-out bulb, unplug
the refi'igerator fl'om its electrical outlet,
unscrew tile bulb when cool and replace
it with an appliance bulb of the same or
lower wattage.
Turning the centre/to the0 position doesnot
removepower to the//_Tht circuit.
Preparing for Vacation
For long vacations or nbsenres, remo\ e
fl)od and unplug tile refi'igeratm: Move
the temperature control dial to tile 0
position, and clean the interior with a
baking soda solution of one tablespoon
(15 ml) of baking soda to one quart
(1 liter) of water. Leave tile doors open.
Set the icemaker power switch to tile
O (Off) position or move the feeler arm to
tile STOP (up) position (depending on
model) and shut off tile water supply to
tile reti'igerator.
If tile temperature can drop below
fl'eezing, have a qualified servicer drain
tile water supply system (on some models)
to prevent serious property damage (Isle
to flooding.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely in place to prevent damage.
Be sure the refn)erator stays in an upr/)ht
position dunbg rnov/bg.
70