Page 1
HOOVER_ FoldAway Upright Thank you for your purchase! Owner's Manual ENGLISH ,,_ pp. 1-12 ESPANOL ,,_ pag. 15-21 FRANGAIS ,,_ p. 22-28 www.hoover.com...
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
Page 3
If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR Call 1-330-499-9499 to speak with a representative...
Page 5
Transporting cleaner Carrying handle Carpet height adjustment Put handle in upright position. Tilt Use the carrying handle to lift the cleaner back on rear wheels. Push cleaner. The cleaning of carpet and rugs takes forward. place at the nozzle (B). When it is necessary to raise and lower the nozzle for various carpet pile heights, turn the carpet height adjustment knob (C) to...
Cleaning tools Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. CAUTION: Agitator continues to rotate while cleaner handle is in upright position.
Familiarize yourself withthese home When to empty maintenance tasks asproper u seand It is recommended that the dirt cup be careofyour c leaner will e nsure c ontin- emptied before the dirt reaches the dirt uedcleaning e ffectiveness. opening on back of dirt cup (Fig. 4-2) or after every use if preferred.
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. Disconnect cleaner from electrical Pull old bulb straight out of socket. Snap access door into place. outlet.
,JUU Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good con- dition.
When purchasing a new agitator, ask for 4. When cleaner is unplugged 13" - HOOVER part no. 48414110 Lubrication the motor cools for 30 minutes, the thermal protector automatically resets 15" - HOOVER part no. 48414115.
(U.S. only). blockage is found: (this will reset the thermal protector) Turn cleaner OFF and disconnect from (see pg. 10). electrical outlet. Do not send your cleaner to The Hoover Company in North Canton for service, • • • •...
For an automated referral of authorized service outlets in the U.S.A., phone 1-800-944=9200 OR visit The Hoover Company on=line at www, hoover.com This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory...