Removing Hood; Position New Belt On Agitator Brush Roll; Installing Agitator Brush Roll - Hoover Nano-Lite U2440-900 Owner's Manual

Remove 2 screws from bottom plate.
Removing hood
Lower cleaner base so it is flat on
the floor.
Remove 2 screws located at back of
hood (A). Lift hood off.
Remove 2 screws on agitator cover
(B).
Lift agitator cover off.
Grasp agitator (C) and pull up to
remove trom agitator cavity.
Slide belt (D) off agitator.
Remove belt from motor shaft (E).
Discard used belt.
Position new belt on agitator
brush roll
With lettering on outside of belt,
insert agitator brush roll through belt
and position belt in groove (F) on
agitator brush roll.
installing agitator brush roll
Grasp agitator brush roll firmly and
fit it into position by first sliding end
opposite the belt into the rectangular
slot (G) on side of cleaner.
Pull other side of agitator brush roll
into place.
Reposition agitator cover over
agitator. Replace 2 screws.
10