Advertisement
The assembled cleaner will look like this
drawing (Ultra mode_ shown).
Attach
upper
handle
_1_ Remove clean solution tank (upper
tank) from deep cleaner
[]
A
_1
With cord hook (A) to back of deep
cleaner, push upper handle down onto
lower handle. Push bolts into holes on
front of handle. If bolts will not go
through hole easily handle is not pushed
completely down.
[]
D
Place nuts in recessed areas on
back of handle. Hold each nut in
place while tightening
each bolt securely
with a Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience
|
DWhen
handle sections are complete
ly together, squeeze trigger (B) on
upper handle to snap trigger rod in
place.
D
Replace clean solution tank (upper
tank) by positioning
bottom first.
Press on tank handle to snap top of
tank into place.
DPress
cord into cord clip on back of
handle. Pull cord tight.
Attach
hose
clip
D
Push tab on side of clip into hole on
side of handle,
_1
Pivot clip and push other tab into
hole at back of handle to lock into
place,
Advertisement
