Table of Contents
Advertisement
USING THE REMOTE
TO CONTROL
VCR FUNCTIONS
Operating the precoded function
for your VCR.
This remote is designed to operate different types of VCRs.
VCR. (Refer to page 34.)
1.
2.
3.
4.
5.
You must first program the remote to "hatch the remote system of your
Turn ON your VCR.
Aim the remote control at the front of your VCR.
Press the VCR button to switch to the VCR pre-coded mode.
Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR as shown in pag,._. 34. The remote
will turn off your VCR when the correct two digit preset code is entered.
When this occurs, t3e remote control is programmed for
your VCR. If the VCR does not turn off after five seconds, try a different two digit preset c_3de.
The remote will now control your VCR.
NOTES:
1.
If your VCR cannot be operated after performing the above procedures, your VCR code has not been precoded into the remote.
2.
In the unlikely event that your VCR cannot be operated after performing the above proc,edures, please consult your VCR
operating guide.
3.
The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After
replacing the batteries repeat the entire programming procedure as stated above.
4.
If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
5.
The MENU button will act as the VCR MENU button for HITACHI VCRs.
6.
The LST-CH button will act as your VCR ENTER button if required.
7.
The SLEEP button will act as your VCR '100' button if required.
O
VCR Button
This button allows the remote to control your VCR by setting it to VCR mode.
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button twice to record
a program.
Q
EXCLUSIVE "IV Buttons
These buttons are for operating the "IV.
I
NOTE:
Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.
31
Advertisement
Table of Contents
