Haier HWR06XC3-T User Manual page 18

PREPARE
WINDOW FOR
INSTALLATION
1, This unit is designed for installation in standard double hung windows
with actual opening widths of 22" to 36". The upper and lower sash
must open sufficiently to allow a clear vertical opening of 14" from the
bottom of the sash to the window stool.
2. If storm window presents interference, fasten a 2" wide wood strip(not
included) (OUTER SILL) to the inner window sill across the full width of
the sill. The wood strip should be thick enough to raise the height of
the window sill so that the unit can be installed without interference by
the storm window frame (STORM WINDOW FRAME) or wood strip
(OUTDOORS) to help condensation to drain properly to Ihe outside,
3. Install a second wood strip (approximately 6 *_long by 3/2" wide and
same thickness as first strip) in the center of the outer sill flush against
the back off the inner sill. This will raise basepan angle .
4, If Ihe dislance belween STORM WINDOW FRAME and WOOD STRIP
MOUNTED ON TOP OF INNER SILL is more than 1", two of wood
strip are not necessary.
INNER
SILL
U
oS I
R _ O O
Open the window and mark center line on the
center of the inner sill.
INNER SI_
INDOOR SIDE
ATTACH BASEPAN
ANGLE
Install the basepan angle behind the inner window sill, with
the short side of basepan angle as showm Use the 2 short
screws t 3/32" provided.
The basepan angle helps to hold unit securely in place.
Be sure to place basepan angle edge flush against back
of inner silk
INNER SILL
SHORT SCREW13/32"
OUTER SILL
CENTER LINE
INSIDE
SHORTSIDE
OUTSIDE
BASEPAN ANGLE
17