GE AGW10 Owner's Manual And Installation Instructions page 5

ge.com
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOLMode
Use the COOL mode with HIGH (F3), MED (F2) or
LOW(FI)
tim fin"
cooling.
Use tile INCREASEA
/
DECREASEV
pads to set tile desired temperature
between
60°F and 86°F in l °F increments.
An electronic them/ostat is used to maintain tile
room temperatm'e. Tile compressor will cyde on and
off to kee I) tile room at the set level ot comfi)rt. Set
tile them/ostat at a lower nmnber and tile indoor air
will become coole_: Set tile them_ostat at a higher
number and tile indoor air will become wam/e_:
NOTE:ff the air conditioner is off and is then turned on
whileset to a COOL settingor if turnedfrom a fan setting
to a COOL setting, it will take approximately3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
For Normal Coolin#---Sele('t tile COOL mode and
HIGH (F3) or MED (F2)tim with a middle set
temperature.
ForMaximum
Cooliug--Select
tile COOL mode
and HIGH(Fd)tim with a lower
set temperatm'e.
For Quieter & Nighttime Coolinl_--Select tile
COOL mode and LOW (F1)tim with a middle set
temperatm'e.
NOTE:If you switch from a COOL setting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use tile FANat HIGH(F3), M ED (F2)or LOW(FI) to
provide air circulation and filtering without cooling.
Since tim only settings (lo not provide cooling,
a temperature setting will not be displayed.
Vent Control
Tile vent control is located above tile control
panels.
When set at CLOSE, only the air inside the room
will be circulated and conditioned. When set at
OPEN,
s ome inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it in.
Air Direction--Side-to-Side
Tile side-to-side air direction
is a(!i usted by moving
tile lever
to tile left or fight.
Air Direction--Up and Down
Fingertip pressm'e on tile horizontal lou\'e_
ac!iusts tile air direction up or down.