GE AGW10 Owner's Manual And Installation Instructions page 12

Installation Instructions
[] INSTALL THE WINDOW LOCKING
BRACKET AND THE FOAM TOP
WINDOW GASKET
[] Attach a support bracket with a Type C
screw.
[] Cut the foam top window gasket to the
window width.
[] Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
/
[] INSTALL THE AIR CONDITIONER
IN THE CASE
I_q Slide the air conditioner into the case.
Inl
Reinstall the 2 screws removed earlier on
each side of the case.
Screw Screw
[] INSTALL THE AIR CONDITIONER
IN THE CASE (CONT.)
[] Before installing the front grille, pull out the
vent control lever located above the unit
control knobs, as shown.
[] Attach the front grille to the case by inserting
the tabs on the grille into the slots on the
front of the case. Push the grille in until it
snaps into place.
[]
, ._=_
Guide the lever carefully
flTroughthe grille as you
push it in.
L.
Lower the inlet grille and secure the front
frame with a type A screw through the
front grille. Raise the inlet grille back
into place.
12