GE AZ58H12EADM1 Owner's Manual And Installation Instructions page 15

Installation Instructions
265 VOLT ELECTRICAL SUPPLY
/k WARNING:
Connection of this 265 V AC product to a branch circuit
MUST be done b) direct connection in accordance with
the Natkmal Electric (;()de, Plugging this unit into a
building mounted exposed receptacle is not permitted
b) code,
These models must be installed using the appropriate
GE power suppl} kit ti)r the branch circuit amperage
and the electrical resistance hearer wattage desired,
See the POWER CONNECTION (;HART in these
Installation Instructions. One of the tbllowing
installation methods must be used:
A Elecu'ical subbase kits are available to provide a flexible
enclosm'e for direct c(mnecfion,
Branch Circuit and Proper GE Power
Unit Amperage Rating Subbase Kit Supply Kit
15 ILM4204E 15 ILM(5172
20 ILM4204E20 1,LM(5202
30 I, L M4204E30 1LM(5302
The instructions pr_Mded wifll the selected subba_ kit must
be cm'efld b ti)llo_d, It is the responsibilit) of the installer
to
ensIlre the connection of colrll)onents is done in
accordance with these instructions and all elecu'ical codes,
B
For direct c(mnecdon to branch circuit wi_Jng inside the
provkted j unction box without using a subbase kit, cut
the cord, strip the wire ends and c(mnect as fi)llo_:s,
[] REMOVE JUNCTION BOX
1 Remove thejmlction box cover by taking out the
fl'ont Ibm" screws.
2 Remove thejmlction box by taking out the top rear
screwy. Note how the tab on the lower right corner
of the j unction box serves to hold the side in place.
This will hel I) when the box is being reinstalled.
The cord will be coiled up inside the junction box,
ff
box cover
Junction-
box
I
15
[] CUT AND STRIP THE CORDSET
1 Remove the cordset from the power supply kit.
Measure 6" down the cord fl'om where it emerges
fl'om the back of the nylon plastic connector
and cut the cord through at tiffs point.
2 Carefifllv remove 3" of the cordset insulation
so as to expose the three insulated wires.
3 Strip 3/4" of the insulation away at the end
of each of the three wires (I,1, Neutral and
Grotmd). Plug the connector fidlv into place
in the trait mating connector. Be sure the
locking robs at the sides are engaged.
3/4"
NOTE: Order Kit RAK4002(_'\ to enable a quick
disconnect inside tim jtmction box.
I
[] ATTACH CONDUIT
1 Lrse the rotmd knockout at tim bottom of tim
junction box to attach conduit coming fl'om tim
branch circuit. Remove tim knockout, attach tim
conduit and bring wires into tbejtmction box.
I,eave 6" of wire fl'ee at the end oI the conduit
to allow
connections to
be
II/ade.
.o.-"
_-"_
_¢"" ;--j'" <---Conduit
If a filse and fllseholder are to be used, the
knockout at the top of the box is fi_r mortaring
a Buss Fusel_oldet; Be sure the filse and filseholder
are of the same rating as the branch circuit.
I,eadwires at the fllse can be either soldered in place
or am_ched using UiAisted 1/4" temale (receptacle)
ci'ilil l) connectoi3.