Normal Operating Sounds - GE AZ55H12EABM1 Owner's Manual And Installation Instructions

Thingsthat are normal
Normal Operating Sounds
PING! POP!
You may hear a pinging noise caused by water being
picked up and thrown against tile condenser on
rainy da):s or when the humidiQ' is high. This design
teatm'e helps relnove moistm'e and improve
efficiency.
"CLICK"
Y})u max hear relm_ click when tile controls cycle
on and off or are a(!iusted to change tile room
temperatm'e.
DRIP
6
X,%_ter will
collect in tile base pan dining
high
humidit_ or on rain) days. Tile water may oxertlow
and drip fl'om tile outdoor side of tile refit.
WHIR!
Tile indoor tim runs continuously when tile refit is
operating in tile cooling mode, mfless tile tim switch
behind tile room cabinet is set at tim cycle (up).
This will cause the tim to cycle on and off with the
COiill)i'essoi: You IIlay
also hear
a t_lil
noise stop
and start.
_t
Y)u may notice a tew minutes delay in starting if you
tiT to restart tile Zoneline too soon after turning it
off or if you a(!iust tile them/ostat right after tile
compressor has shut ofl_ This is due to a built-in
i'estart l)rotector t()i" tile COllll)i'essor that Catlses
a 3-minute delay.
During tile deti'ost cycle, both indoor and outdoor
rims stop and tile compressor will operate in tile
cooling illode to rell/Ove ti'ost J[i'Olil tile o/ltdooi"
coil.
_Mier defl'ost, tile refit will restart in electric heat to
quickly warm tile room to tile desired comfi)rt level.
COMPRESSOR
PROTECTION
To protect the
COI/ll)I'essoI" and l)I'event shoI't
cycling, tile refit is designed to rtm fin" a minimum
ot 3 minutes, alter tile compressor starts at anv
them_ostat setting,
2O