Advertisement
Performance
Data Sheet
SmartWater
Filtration
System
MWF Cartridge
This sgstem has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.
The concentration
of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANS! 42/53.*
(100% safetb, factors built in for unmetered usage)
USEPA
Influent
Parameter
MICL
Challenge Concentration
Chlorine
-_-
2,0mg/L_.10%
T&O
-
-
Particulate**
-
_ 10,000partides/mL
Standard No, 42: Aesthetic Effects
Influent
Effluent
Average
Average
/Maximum
1,96mg/L
0,06mg/L
0,11mg/L
6,400,000 #/mL
58,833#/mL
150,000 dmL
% Reduction
Average
/Minimum
96.77%
94.74%
99.14%
97.97%
Parameter
Turbiditg
Cgsts
Asbestos
Leadat pH6,5
Leadat pH8,5
I'qercurg at pH6,5
1'4ercurg a t pH8,5
Aiachlor
Lindane
2,4--D
Toxaphene
Benzene
Carbofuran
1,4 dichlorobenzene
Atrazine
USEPA
MICL
0.5 NTU
2 99.95%Reduction
2 99%Reduction
0.015mg/L
0.015mg/L
0,002mg/L
0,002mg/L
0,002mg/L
0.0002mg/L
0.070mg/L
0,003mg/L
0,005mg/L
0,040mg/L
0,075mg/L
0.003mg/L
Standard
No. 53: Health Effects
Influent
Challenge Concentration
11+ 1 NTU***
Minimum50,000L
107to 108fibers/L; > 10tJm
0,15mg/L+ .10%
0,15mg/L+ .10%
0,006mg/L+ 10%
0,006mg/L+ 10%
0,04mg/L+ 10%
0.002mg/L+ 10%
0.210mg/L+ 10%
0,015mg/L+ 10%
0,015mg/L+ 10%
0,080mg/L+ 10%
0,225mg/L+ 10%
0.009mg/L+ 10%
Influent
Average
10.5NTU
118,7%#/L
57 MF/L
0.1567mg/L
0.1453mg/L
0.0059mg/L
0.0057mg/L
0.0367mg/L
0.0020mg/L
0.203J' mg/L
0.0160mg/L
0.0145mg/L
0.0830mg/L
0.2283mg/L
0.0087mg/L
Effluent
Average
0.14NTU
< 1 #/L
0,996MF/L
< 0,001mg/L
< 0,001mg/L
0.000350 mg/L
0.000325 mg/L
0.00023 mg/L
< 0.00002 mg/L
0.0033r1-7
mg/L
0,00]00rng/L
0.000500 mg/L
0,00]000mg/L
0.000500 mg/L
< 0.0005mg/L
/Maximum
028 NTU
4#/L
< ] MF/L
<0,00] mg/L
<0,001mg/L
0.0007mg/L
0.0006mg/L
0.0004mg/L
< 0.00002 mg/L
0.011000 mg/L
0.001000 mg/L
0.000500 mg/L
0.001000 mg/L
0.000500 mg/L
< 0.0005mg/L
% Reduction
Average
/Minimum
98.54%
97.20%
> 99.99%
> 99.99%
99.60%
99.39%
99.36%
99,29%
99.30%
99,29%
94.70%
87.50%
93.20%
89,29%
99.34%
98,67%
99.00%
98.95%
98.32%
94.50%
93,44%
9].67%
96.51%
95,83%
98.78%
98.65%
99.78%
99.77%
94.22%
93.33%
Tested using a flow rote of 0.50 gpm; pressure of 60 psig; pH of 7.5 +_ 0.5; temp. of 68 ° _+ 5°F (20° _+ 3°C)
** Measurement in Particles/m/. Particles used were 0.5-1 microns
*** hlTU=hlephe/ometric Turbiditg, units
Mlin. Required
Reduction
> 50%
2 85%
Mlin. Required
Reduction
05 NTU
99.95%
99%
0,010mg/L
0,010mg/L
0,002mg/L
0,002mg/L
0,002mg/L
0.0002mg/L
0.070mg/L
0,003mg/L
0,005mg/L
0,04mg/L
0,075mg/L
0.003mg/L
Operating Specifications
M Capacitg: certified for up to 300 gallons (1135 I); up to one gear
M Pressure requirement:
40-120
psi (2.8-8.2 bar), non-shock
I Temperature:
33-100%
(0.6-38°C)
M Flow rate: 0.5 gpm (1.9 Ipm)
General lnstallation/Operation/Haintenance
Requirements
M Flush new cartridge
at full flow for 3 minutes to purge out trapped
air.
M Replace cartridge
when the indicator
light flashes.
Special Notices
I Installation
instructions,
parts and service availabilitg,
and standard
warrantg
are included with the product when shipped.
M This drinking water sgstem must be maintained
according to manufacturer's
instructions, including replacement
of filter cartridges.
M Do not use with water that is microbiologicallg
unsafe or of unknown
qualitg without
adequate
disinfection
before or
after the sgstem. Sgstems certified
for cgst reduction
mag be used on disinfected
water that mag contain filterable
cgsts.
I The contaminants
or other substances
removed
or reduced bg this water treatment
sgstem are not necessarilg
in gour waten
M Check for compliance
with the state and local laws and regulations.
M Note that while the testing was performed
under standard
laboratorg
conditions,
actual
performance
mag varg. Sgstems must be
installed and operated
in accordance
with manufacturer's
recommended
procedures
and guidelines.
Standard No. 42: Aesthetic Effects
Chemical Unit
Chlorine Taste and Odor
Mechanical Filtration Unit
Particulate Reduction, Class I
Sgstem Tested and Certified bg NSF International against ANSI/NSF Standard 42 & 53 for the reduction of:
Standard No. $3: Health Effects
Chemical Reduction Unit
Alachlor and Atrazine Reduction
Benzene and Carbofuran Reduction
1,4 dichlorobenzene and 2,4-D Reduction
Lead and Lindane Reduction
Mercurg and Toxaphene Reduction
Mechanical Filtration Unit
Turbiditg Reduction
Cgst and Asbestos Reduction
Manufactured for: General Electric Compang, Louisville, KY40225
EPAEST.No. 070595-MN-001
27
Advertisement
