GE DBVH520 Owner's Manual page 8

About the dryer control panel.
O Dry Temp
You can change the temperature of your dry cgcle.
ANTI-BACTERIAL
(on some models)
This option may only be used with COTTONS or MIXED LOAD cycles. This option reduces
certain types of bacteria by 99.9%, including: Staphylococcus oureus, Pseudomonos
oeruginoso and Klebsiello pneumonioe*. The anti-bacterial process occurs when high
heat is used during u portion of this drying cycle.
NOTE: Do not use this cycle on delicate fabrics.
* The Anti-Bacterial Cycle is Certified by NSF International {formerly Notional Sanitation
Foundation) to NSF Protocol P154 Sonitizotion Performance of Residential Clothes Dryers.
NSF Protocol P154 ]
S mitJz_doll Perfbrma_tc_' of
Residential (_]othes Dryers
HIGH For regular to heavy cottons.
MEDIUM For synthetics, blends and items labeled permanent press.
LOW For delicates, synthetics and items labeled Tumble Dry Low.
EXTRA LOW For lingerie and special-care fabrics.
NO HEAT Can only be used with TIMED DRY.
(on some models)
O START
Press to start a dry cycle. If the dryer is running, press it once and it will pause the drgeE
Press it again to restart the dry cycle.
My Cycle ton somemodels)
Set up your favorite combination of settings and save them here for one touch recall,
These custom settings can be set while a cycle is in progress.
To store a MY CYCLEcombination of settings:
/.. Select your drying cycle.
2. Change DRY TEMP and SENSORDRY LEVEL settings to fit gout needs,
3. Select any drying OPTIONSyou want.
4. Press and hold the _ pad for three seconds to store gout selection. A beep will sound
and the pad will light up.
To recall your stored MV CYCLEcombination:
Press the MY CYCLEbutton before drying a load.
To change your stored MY CYCLE combination:
Follow steps 1-4 in "To store a MY CYCLE combination of settings'.
0
"CLEAN LINT FILTER" (message)
(This message represents only a reminden)
After the POWER button is pressed, the "CLEAN LINT FILTER" message could appear if the previous
cycle was not finished.
This message will disappear after the STARTbutton is pressed. Even though you have already cleaned
the filter (before or after the POWER button has been pressed), the "CLEAN LINT FILTER" message will
still be displayed until the STARTbutton is activated.
8