GE DBVH520 Owner's Manual page 23

Before you call for service.., gecom
_ roubleshooting Tips
Save time and moneg! Review the charts on the following pages,
or visit Be.cam You mob not need to call for service.
PROBLEM Possible Causes What To Do
Dryer shakes or Some shaking/noise is normal. • Hove dryer to an even floor space, or adjust leveling legs
makes noise Dryer may be sitting unevenly as necessary until even.
Clothes take too long Improper or obstructed ducting • Check the Installation Instructions to make sure
to dry the dryer venting is correct.
• Hake sure ducting is clean, free of kinks and unobstructed.
• Check to see if outside wall damper operates easily.
Improper sorting • Separate heavy items from lightweight items (generally,
a well-sorted washer load is a well-sorted dryer load).
Large loads of heavy fabrics • Large, heavy fabrics contain more moisture and take
(like beach towels) longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
Controls improperly set • Hatch control settings to the load you are drying.
Lint filter is full • Clean lint filter before every load.
Blown fuses or tripped circuit • Replace fuses or reset circuit breakers. Since most
breaker dryers use 2 fuses/breakers, make sure both are
operating.
Overloading/combining loads • Do not put more than one washer load in the dryer at
a time.
Underloading • If you are drying only one ortwo items, add a few items
to ensure proper tumbling.
The DRY dryness level Load consists of a mixture • When combining heavy and light fabrics in a load,
was chosen but load is of heavy and light fabrics choose MORE DRY
still damp
Exhaust system is blocked • Inspect and clean exhaust system.
Controlpods not Controls accidentally put in • Press STOP.
responding service mode
Controls accidentally put in • Hold the LOCKbutton for 3 seconds to unlock the dryer
lock mode
Controls performed an • Reset the in-house breaker
incorrect operation
Dryer doesn't start Control panel is "asleep" • This is normal. Press POWER to activate the control panel.
Dryer is unplugged • Hake sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker • Check the building's fuse/circuit breaker box and
is tripped replace fuse or reset breaker NOTE: Electric dryers
use two fuses or breakers,
Dryer was accidentally paused • If the light on the DELAY START pad is flashing, the
when starting Delay Start drger is paused. Press STARTto restart the countdown.
No numbers displayed Dryer iscontinuously
during cycle, only lights monitoring the amount of
moisture in the clothes
• This is normal. When the dryer senses a low level of
moisture in the load, the dryer will displag the dry time
remaining.
23